![]() But the reply "Login:" is not recognized as a valid sequence and the connection is then aborted. (probably the start of the good old Hayes protocol). When the modem connection is established, windows sends some newlines to get a reply from the remote side The interesting part comes up when looking at the modem log (which one has to activate in the first place). The PPP link control protocol was terminated." When OMC tries to connect to the OXO, I only get The direct serial connection works (tested with hyperterminal), the login prompt is shown. That's why I wan t to connect OMC R22.0.7.1a to the OXO via V24. The IP address of the OXO R7.10 is unknown, ping scans in the usual private ipv4 address spaces did not return any result. OXO does not get any IP on DHCP pool configured for that range - I see MAC address on port where OXO is connected, though.Īny help on serial port wiring/connection would be (very) appreciated! I even tried to put a cable from LAN port to a switch, configured with a VLAN on 192.168.92.x /24 (since it seems that default address of OXO is somewhere in that range). I use PuTTY w/ default settings (9600,n,8,1). I then put a straight cable from that adapter to 'Config' port of OXO, but I get absolutely nothing, only garbage (3 characters) at the very beginning of the boot. I built an adapter, made from an old grey Cisco adapter (DB9 female to RJ45 female), rewiring pins on DB9 female that way (pinout found on that forum): I'd like to get a basic connection to an OXO compact edition, via 'Config' port on CPU-4 board, with PuTTY, to try to log in. ![]() I'm totally new to Alcatel OXO (but I use Cisco devices for a while).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |